Resin Infusion

Basic consumables set to make your first resin infusion or a small project or repair. materials for 1m2

The easiest and most economical solution to have an effective resin trap

SR 8100 epoxy resin with SD 8824 hardener (Standard) specific for resin infusion.

Apply the Peel ply to the entire surface you want to separate from the fiberglass / carbon and other consumables.

Perforated Polyethylene film that detaches from most resin systems - for infusion and vaccuum works

Bag for infusion or vacuum. 50 microns, orange, 30cm width (tubular)._x000D_

mesh tube mesh Yb1 infusion input

complex 1,5m x 100m_x000D_ _x000D_ the COMPLEX mesh integrates the drainage mesh, the perforated film and even the Peel Ply, and saves time, resin and effort in separating the consumables from the finished piece.

Flowmesh is a perfect drain mesh for learning, thanks to its flexibility and ease of application. It comes with black weft threads that indicate the optimal resin flow direction. Thanks to its great flexibility, it is the most recommended mesh for small surfaces with complicated, angular areas.

Sealing tape for the vacuum bag, 15 meter roll, ideal for resin infusion, vacuum compaction and sealing all joints, from the bag to the pump, through the resin trap.

Vacuum bag for infusion or vacuum. 65 microns, blue, width 2 meters (folded in half)

Jaw / Pliers to close the passage of resin or air in the resin infusion system for composites. Total hose tightness quickly and easily.

Pyramid for infusion, for 12 mm hose To connect the distribution system with a resin inlet and outlet hose. Made of high density polyethylene.,

SORIC SF-2 MM

Removable glass / carbon fiber sealant. It does not affect the mechanical properties of the infused piece

Low density polyethylene spiral, for resin distribution in an infusion system.

10X12MM 60ºC infusion hose

Suitable for small vacuum systems, it saves resin by having a smaller inside diameter.