FLOWMESH LIGHT INFUSION MESH 125 CM 1 M2

Low density polyethylene spiral, for resin distribution in an infusion system.

Perforated Polyethylene film that detaches from most resin systems - for infusion and vaccuum works

10X12MM 60ºC infusion hose

SR 8100 epoxy resin with SD 8824 hardener (Standard) specific for resin infusion.

Suitable for small vacuum systems, it saves resin by having a smaller inside diameter.

Sealing tape for the vacuum bag, 15 meter roll, ideal for resin infusion, vacuum compaction and sealing all joints, from the bag to the pump, through the resin trap.

Vacuum bag for infusion or vacuum. 65 microns, blue, width 2 meters (folded in half)

Apply the Peel ply to the entire surface you want to separate from the fiberglass / carbon and other consumables.

SORIC SF-2 MM

Basic consumables set to make your first resin infusion or a small project or repair. materials for 1m2

Removable glass / carbon fiber sealant. It does not affect the mechanical properties of the infused piece

Jaw / Pliers to close the passage of resin or air in the resin infusion system for composites. Total hose tightness quickly and easily.

The easiest and most economical solution to have an effective resin trap

mesh tube mesh Yb1 infusion input

complex 1,5m x 100m_x000D_ _x000D_ the COMPLEX mesh integrates the drainage mesh, the perforated film and even the Peel Ply, and saves time, resin and effort in separating the consumables from the finished piece.